Hannah Luedeke

  • Total activity 47
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 0
  • Subscriptions 27

Articles

Recent activity by Hannah Luedeke Sort by recent activity Recent activity Votes
  • My Gateway isn't Reporting

    If your InfrastructureAI gateway has been setup with an ID and token in InfrastructureAI, then in most cases, once your gateway is plugged in on your network using a PoE switch, then it will begin ...

  • Why can't my IAI Gateway see my equipment?

    First, double-check to make sure your connection information is correct in InfrastructureAI (under My Equipment > [your gateway] > [your piece of equipment] > Edit Icon). Make sure you haven't fat-...

  • Configuring a Network for InfrastructureAI Gateways

    DHCP IAI gateway is setup default as DHCP. Plug the gateway into the network. The gateway will establish a connection with the IAI cloud service by using the outbound “phone home” feature.   The ga...

  • Configuring SNMP Traps on Liebert/Vertiv UNITY-DP Cards

    InfrastructureAI gateways can listen for SNMP traps to help you diagnose problems with your equipment. Learn more about SNMP traps and how IAI uses them here.  To setup traps on a Vertiv Unity Card...

  • The Countdown Widget

    The countdown widget is one of the many widgets available to you on a view. Use a countdown widget to create a timer to remind you to do a task. Typically, equipment has maintenance that needs to b...

  • Maintenance Mode

    InfrastructureAI supports maintenance mode on connected pieces of equipment. When activated, maintenance mode deactivates all texts and emails typically sent to users when an alarm is triggered or ...

  • Configuring SNMP Traps for a ServersCheck Gateway

    InfrastructureAI gateways can listen for SNMP traps to help you diagnose problems with your equipment. Learn more about SNMP traps and how IAI uses them here.  To setup traps on a ServersCheck gate...

  • SNMP Traps

    SNMP Traps are alert messages sent from an SNMP-enabled device to the IAI gateway. Traps provide information during an alarm event that is useful for diagnosing an issue. IAI does not rely on traps...

  • Restarting a Vertiv UNITY-DP Card

    Restarting a Unity Card is required for many Unity Card configuration changes. It usually takes around 5 minutes for the card to restart. Under the Communications tab on the left-hand side, click o...

  • Setting up SNMP Traps on Vertiv UNITY-DP cards

    Navigate to your unity card's web portal by entering its IP address into your web browser. Enter the login credentials for the card (if applicable). Select the ’Communications’ tab near the top of...